Spark Logic

APW8805 / APW8805A / APW8805B buck converter connection guide

APW8805 / APW8805A / APW8805B buck converter (TDFN 3 × 3 mm (QB)) connection guide. Build the 1.05 V buck circuit. Check enable and power good.

TDFN 3 × 3 mm (QB)

11 contacts Current package

ANPEC Electronics · Ten perimeter leads and one exposed ground pad.

Automatic PFM/PWM; documented startup into a pre-biased output. Order code: APW8805BQBI-TRG.

Build the 1.05 V buck circuit

Required

With power off, join VIN and VCC to the same 2.6–6 V rail. Join both SW pins, keep that copper compact, and leave NC open. Drive EN low during initial power-up. The optional feed-forward capacitor across R1 is omitted in this drawing.

Build the 1.05 V buck circuitVIN22µ100kENPOKVINVCCAPW8805SW1.5µHVOUT4.7kFB15k2×22µGND / EPGND
  • Input
    • CIN.1
    • RPG.1
    • Input supply positive
  • Ground
    • CIN.2
    • COUT1.2
    • COUT2.2
    • R2.2
    • Input return
  • Enable
    • →
    • Enable control
  • Switch node
    • →
    • →
    • L1.1
  • Output
    • L1.2
    • R1.1
    • COUT1.1
    • COUT2.1
    • Load positive
  • Feedback
    • →
    • R1.2
    • R2.1
  • Power good
    • →
    • RPG.2
    • Power-good monitor

Bench checks

  • Verify continuity from pins 4, 5 and the exposed pad to ground. Check VIN for shorts before applying a current-limited supply.
  • Drive EN high after the input has settled. The divider sets 0.8 × (1 + 4.7/15) ≈ 1.05 V nominal. Check at the output capacitor.
  • Choose L1 for the peak inductor current, and check capacitor effective capacitance under bias, ripple and PCB temperature before increasing load.

ANPEC APW8805B Rev. A.2, Typical Application Circuit, p. 7

Connection scenarios

TDFN 3 × 3 mm (QB) wiring map

External wiring example · Build the 1.05 V buck circuit

Highlighted contacts are used in the required step or selected circuit. Select a contact to highlight its wiring nets.

TDFN 3 × 3 mm (QB) · Top view, with pin 1 at upper left. The exposed ground pad is on the underside.
Dashed outline shows the underside pad schematically. See the package drawing for the footprint.
Selected pin details

9 · POK

Output · Outputs

Open-drain status output. Add a pull-up; check the receiver voltage rating.

ANPEC APW8805 / A / B datasheets, p. 2 and Pin Description

Connected nets

Electrical limits · Pin in the reference

Models and documents

Choose the exact suffix for the enable thresholds and light-load behavior. The APW8805B overview lists 0.6 V as a minimum output, while its feedback specification and application equation use 0.8 V. The circuit here uses the documented 0.8 V reference.

APW8805
Automatic PFM/PWM. Order code: APW8805QBI-TRG.
APW8805A
Forced PWM. Order code: APW8805AQBI-TRG.
APW8805B
Automatic PFM/PWM; documented startup into a pre-biased output. Order code: APW8805BQBI-TRG.