FN-M16P serial MP3 module connection guide
FN-M16P serial MP3 module Flyron FN-M16P, 16 contacts wiring guide with power, signal assignments, and bench checks.
Flyron FN-M16P, 16 contacts
16 contacts Current packagePlay a known microSD track
RequiredCopy a short test track to /MP3/0001.mp3 on a FAT32 microSD card. Insert the card with power off. Use a regulated 5 V supply, a 3.3 V logic UART and one 8 Ω speaker across pads 6 and 8.
- 5 V supply
- VCC (1)
- Regulated 5 V
- C1.1
- Ground
- GND (7)
- GND (10)
- Supply return
- Host ground
- C1.2
- Host to module
- RX (2)
- Host UART TX
- Module to host
- TX (3)
- Host UART RX
- Speaker contact 1
- SPK (6) (6)
- Speaker terminal 1
- Speaker contact 2
- SPK (8) (8)
- Speaker terminal 2
- Playback indication
- BUSY (16)
- 3.3 V logic analyzer input
Bench checks
- Set the UART to 9600 bit/s, 8N1. Wait for the startup frame with command byte 0x3F before sending a command.
- Send 7E FF 06 06 00 00 04 FE F1 EF to set low volume. Then send 7E FF 06 12 00 00 01 FE E8 EF to play the named file.
- Check that BUSY goes low while playing. Keep both speaker wires isolated from the ground rail.
Flyron FN-M16P data sheet V1.0, §§ 2, 3.1–3.2, 3.5.1, 3.6.2, 3.6.7 and Figure 5-4.
Flyron FN-M16P, 16 contacts wiring map
Flyron FN-M16P, 16 contacts
5 · DAC_L
Left audio DAC output for an earphone or an external amplifier.
Models and documents
This map follows the 16-contact Flyron FN-M16P board in the manufacturer PDF. Identify the FN-M16P board marking and the two eight-contact rows before using the map.
- Flyron FN-M16P
- The 16-contact microSD module shown in the Flyron data sheet.
- Flyron FN-M16P data sheet V1.0· Flyron original PDF download. Contact assignments, packet format, volume, named-folder playback and speaker connection.
