Spark Logic

HX8352 TFT LCD controller connection guide

HX8352 TFT LCD controller ITDB02-3.2WD · 40-contact header wiring guide with power, signal assignments, and bench checks.

ITDB02-3.2WD · 40-contact header

40 contacts Current package

Himax ·

Bring up the display on a matching ITead carrier

Required

With power disconnected, seat the connector on the matching carrier. Check the GND/DB0 end against the bottom-view drawing. Keep the SD slot empty for the first display test.

Bench checks

  • Use the UTFT profile for ITDB02-3.2WD and the host pin assignments for the carrier. Run a color-fill example.
  • If the backlight turns on and no pixels change, verify display reset and the write strobe. Check both eight-bit halves of the bus if colors are incorrect.

ITead Studio ITDB02-3.2WD v1.0, pp. 2–4 and bottom-view connector drawing. Himax HX8352-A(T) datasheet, host bus and pin descriptions. ITead module datasheet identifies the fitted HX8352-A.

ITDB02-3.2WD · 40-contact header wiring map

Highlighted contacts are used in the required step or selected circuit. Select a contact to inspect it.

Bottom view with the header below the ITead logo. Start at the rightmost GND/DB0 pair. A is the inner row and B is the outer row.
Selected pin details

B7 · DB6

Input · Inputs

Display data bus bit 6.

ITead Studio ITDB02-3.2WD v1.0, pp. 2–4 and bottom-view connector drawing.

Electrical limits · Pin in the reference

Models and documents

The connector map follows the bottom-view drawing for ITDB02-3.2WD v1.0. Its two rows are labelled A and B here so each position can be selected.

ITDB02-3.2WD v1.0
400 × 240 TFT with TSC2046 resistive-touch controller and SD socket.