Spark Logic

HX8357C TFT LCD controller connection guide

HX8357C TFT LCD controller TM035PDH03 · FPC-45 wiring guide with power, signal assignments, and bench checks.

TM035PDH03 · FPC-45

45 contacts Current package

Himax Technologies ·

Connect TM035PDH03 in 4-wire serial mode

Required

Set IM2:IM0 to 111 before reset. Connect the 3.3 V host and panel supplies to the same regulated rail and ground the unused parallel and RGB inputs.

Bench checks

  • Check the flex orientation, both panel supply voltages, and independent backlight current before sending commands.
  • Observe the active-low reset and compare the first SPI transaction with the module timing diagram. Use the Tianma panel initialization and verify a full-width color test.

Tianma TM035PDH03 V1.0, §§ 2, 4 and 5. Manufacturer PDF hosted by Datasheet4U. The Tianma document describes HX8357C operation as integrated in this module.

TM035PDH03 · FPC-45 wiring map

Highlighted contacts are used in the required step or selected circuit. Select a contact to inspect it.

TM035PDH03 · FPC-45
Locate contact 1 in the module’s mechanical drawing and check the mating connector contact side.
Selected pin details

7 · HSYNC

Input · Inputs

RGB line sync. Ground when unused.

Tianma TM035PDH03 V1.0, §§ 2, 4 and 5. Manufacturer PDF hosted by Datasheet4U.

Electrical limits · Pin in the reference

Models and documents

This map applies to the Tianma TM035PDH03 and its 0.3 mm pitch FPC. The module datasheet specifies the controller interface timing and strap settings.

TM035PDH03
Tianma 3.5-inch TFT module.