Spark Logic

DS212 oscilloscope connection guide

DS212 oscilloscope DS212 external ports wiring guide with power, signal assignments, and bench checks.

DS212 external ports

7 contacts Current package

Miniware / e-Design · Two MCX inputs, a coaxial generator output and Micro-USB.

Charge and power on the oscilloscope

Required

Charge the internal battery with a standard Micro-USB cable if needed. Unplug the cable before the battery-powered loopback check.

  • Charging connection

Bench checks

  • Turn the scope on and check that the display and menu respond.

e-Design DS212 User Manual Rev. 1.1, Device Layout, Quick Start Guide and Calibration.

Connection scenarios

Run zero calibration

Disconnect external signals from both input sockets before using the zero-calibration menu.

Bench checks

  • Go to the third menu page and open Options → Calibration → Calibrate Zero.
  • Press encoder S to open the calibration dialog and press it again to start. Save the calibration data when prompted.

e-Design DS212 User Manual Rev. 1.1, Device Layout, Quick Start Guide and Calibration.

DS212 external ports wiring map

Highlighted contacts are used in the required step or selected circuit. Select a contact to inspect it.

CH A · upper left
Viewed with the screen facing you.
CH B · middle left
Viewed with the screen facing you.
OUT · lower left
Generator output. The center carries the waveform.
USB · right edge
Use a standard Micro-USB cable.
Selected pin details

USB · USB

Charging and data · Bidirectional

Micro-USB port for battery charging and access to the internal disk.

e-Design DS212 User Manual Rev. 1.1, Device Layout, Quick Start Guide and Calibration.

Electrical limits · Pin in the reference

Models and documents

The map covers the external analog sockets and the USB port on the DS212 in the manufacturer’s Rev. 1.1 manual. USB is shown at connector level.

DS212
Connector layout from e-Design DS212 User Manual Rev. 1.1.