Display SPI
The host sends the clock and display data. The separate D/C line distinguishes command or register index from data.
The ILI9225 integrates a 176 × 220 display memory and a TFT controller. The MAR2201 module exposes a write-oriented serial display interface.
Active-low display selection.
| Pin | Signal | Direction | Function |
|---|---|---|---|
| 1 | VCC Supply input | Supply input | Module supply. The manufacturer lists 3.3 V and 5 V operation. |
| 2 | GND Supply return | Supply return | Connect to host ground. |
| 3 | GND Supply return | Supply return | Connect to host ground. |
| 4 | NC None | None | Reserved contact. Leave open. |
| 5 | NC None | None | Reserved contact. Leave open. |
| 6 | LED Input | Input | High enables the backlight. The vendor specifies a 3.3 V high level for continuous operation. |
| 7 | CLK Input | Input | Display serial clock. |
| 8 | SDI Input | Input | Serial data from the host. |
| 9 | RS Input | Input | Register index/data selection. Use the MAR2201 initialization library to drive this line. |
| 10 | RST Input | Input | Active-low hardware reset. |
| 11 | CS Input | Input | Active-low display selection. |
| Parameter | Limit | Conditions and source |
|---|---|---|
| Module supply3.3 V or 5 V | 3.3 V or 5 V | Verify the supply setting on the module before connecting it. LCDWiki MAR2201 interface definition and 2.2-inch SPI board schematic. |
| Panel pixels176 × 220 | 176 × 220 | Portrait address coordinates. LCDWiki MAR2201 interface definition and 2.2-inch SPI board schematic. |
| Pixel formatRGB565 | RGB565 | The module example uses 16-bit RGB values for its color test. LCDWiki MAR2201 interface definition and 2.2-inch SPI board schematic. |
The pin map covers the 2.2-inch MAR2201 module header. The linked Ilitek datasheet describes the controller die and its alternative interfaces.