Spark Logic

Development and computing boards

Red Pill

Discussions and practical resources mentioning Red Pill.

Discussions 11

  1. $10 O-Scope revisited

    ahull

    …g experiment to try. Even 8 bit resolution at say 10MHz would be useful. The GD32F103 red pill boards might also be worth a bit of over clocking experimentation, their silicon should in theory be more amenable to being driven at higher frequencies.
  2. 8-bit|16-bit parallell ILI9341

    RogerClark

    I agree, the Maple mini is a far better board than the Blue or Red Pill, (I don’t think the Red Pill is still available either)
  3. Arduino on Nordic BLE nRF51822

    RogerClark

    …I’d been experimenting with various things.. 3 different BMP boards, (a GD32 board, a Red Pill STM32f103C8 and a Maple mini STM32f103CB) And I had also tried flashing some precompiled firmware to make the nRF51 into a BLE packet sniffer. Anyway, Uploads from t…
  4. Black Magic Probe on an stm32f103c8

    RogerClark

    …her to tie this low as Boot1 only makes a difference when Boot1 is HIGH) The Blue and Red Pill are basically the forums’ names for the board you found on my blog (http://www.rogerclark.net/stm32f103-and … 1-5-x-ide/) e.g you can get them on ebay for a few poun…
  5. Board loses program after boot

    … not work either if I upload then put boot0=LOW I’ve compared the operation with the RedPill board, and its just the Ugly board that won’t start after cold boot. I suspect there is some design…
  6. Hacking the GD32 based ‘Autool X50 OBD2 Monitor and diagnostic Display’

    carl0s

    …de to it. @carl0s may be able to fill in a few more details, as I last played with my red pill GD32 board a couple of years back. Yes that’s right. I had issues with the tvcc pin I think it was – target vcc or vdd, used to check/measure target voltage. Had to …
  7. New wiki

    RogerClark

    …d orphan (or possibly delete the old pages) I’m just adding some info to the Blue and Red pill boards etc.
  8. Red/Blue pill with GD32F103CBT6

    cazimirb

    …re board and a brand new chip would make it easier to solder. BTW, just got a working red pill using the same procedure as for the blue pill.
  9. SD only partially works.

    RogerClark

    …from 3.3V Image However, looking at it, I can see its got a regulator on it. So on my Red Pill board, I change the input voltage from 3.3 to 5V, and this seems to make my cheap / clone 2 Gb SD card more reliable on my Red Pill – but still doesn’t allow me to u…
  10. STM32F091 ADC resolution 10 bit instead of 12 bit

    RogerClark

    … already know the answer is copious. stephen I may try 5v again, because I have 2 old Red Pill boards, which are partially broken already, as the USB connections keep breaking
  11. USBComposite, Some help making a gaming HID…

    BennehBoy

    …BUILTIN PA1 // change to match your board ; PB12 for some black pills ; PC13 for blue/red pill const uint32 leftSwitch = PA7; const uint32 rightSwitch = PA6; const uint32 upSwitch = PA5; const uint32 downSwitch = PA4; const uint32 fireSwitch = PA3; const bool …